Mirzasto – Sandeco

}

FEATURES

– It can be applied easily as it has special fillings inside

– The pattern and sanding can be done easily

– Due its high vapor permeability, it allows surface to discharge the steam and breathe – On MIRZASTO application, there should not be any problem of early drying as the product features don’t allow this

– As it is water-based, it is harmless to human health and environment.

ADDITIONAL FEATURES

The application surface must be cleaned out from every kind of dirt, stain, swelled paint and dust and then uneven surface must be corrected with SAN DECO ACRYLIC PUTTY INTERIOR and primed with SAN DECO DECOPRIMER.

MIRZASTO should be mixed homogeneously without thinning.
– MIRZASTO should be spread with a steel spud, slowly on 1-2 m² area. Then, according to the desired decorative effect, with a plastic or a steel spud, apply the product with untidy patterns. Before MIRZASTO dries, smooth and striped patterns can be applied again with a steel or a plastic spud.
– Wait 4 hours at a temperature of 23˚C, (220/260) then use a grained sanding paper to wipe out the untidy bumps.Finally, according to colour catalogue, first colored EFFECT FİNİSH can be applied one after the other (wait 3 hours between EFFECT FINISH coats)
– The temperature of the application environment must be kept between +5°C and +35°C during application and for 24 hours afterwards.

Allow 4-5 hours for touch dry and 24 hours for complete dry at 23°C environment conditions.

Depending on the surface smoothness, its porosity and the application methods, for a single coat application:
– 1 lt covers 4,0 – 5,0 m² of surface
– 1 kg covers 2,3 – 2,9 m2 of surface
– The paint consumption for 1 m2 area is 200–250 ml and 350–450 gr.